Step 1: Power the devices

1. Plug in KL08RF to 230V
2. Plug in CO10RF coordinator
3. Make sure SQ610RF has batteries and is ON

Step 2: Check LEDs

• On KL08RF – “Network Status” LED should blink (ready to pair)
• On CO10RF – LED should be ON (network active)

Step 3: Start pairing

1. Press “Pair” button on KL08RF (1 second)
   
1. LED blinks faster
   
2. On SQ610RF:
• Go to menu
  
• select “Join ZigBee”
  
• Confirm to join
3. When connected – LED on KL08RF will stop blinking and turn green
   

Step 4: If not connected

1. Press “Reset” on KL08RF (1 sec)
2. Restart SQ610RF
3. Try pairing again

Step 5: Full reset (if needed)

• Press and hold “Pair” for 15 seconds on KL08RF
• Red LEDs will flash 
  
• then go OFF
  
• Try pairing again

Important:

• Do not use CO10RF and UGE600 at the same time
  
• ​After pairing, you can add more thermostats or actuators