iT500 - Pairing with the iT300

iT500 - Pairing with the iT300

 iT500 : Pairing with iT300 Sensor  (2.2.1. 

 

           


    Keys / Buttons needed:  Cog/Settings    Tick/Confirm    Return/Menu 


Description :


Pairing establishes a communications link between your iT500 Thermostat and the iT300 Sensor. If your thermostat is failing to show a temperature for Zone 2 and instead displays two dashes (as below), then your devices need pairing.            Please follow the procedure below. 



                                              


         


Pairing Procedure :  





  1. Remove the battery cover and insert 2 x AAA Alkaline Batteries into the iT300 Sensor.  



  1. Insert a paperclip, pin or similar into the hole on   the left hand side of the sensor for 2 seconds until the red light starts flashing.



  1. A red light will flash in the top right hand corner of the sensor.



  1. On the thermostat press and hold the cog key  and return key  at the same time.



  1. If the device is connected to the internet the globe and WiFi icons will be displayed.



  1. If the device is not connected to the internet just the WiFi icon is displayed.



  1. Press the tick key  - A 10 minute countdown will begin.



  1. On the thermostat, the WiFi Antenna will flash until the devices are successfully paired, at which point the Antenna will remain solid without flashing



  1. The red light on the sensor will continue to flash and then eventually time out.

  1. Once the WiFi Antenna has stopped flashing your devices are paired even if the 10 minute countdown has not completed. To exit pairing press the return key  until the home screen appears.



                                           ____________________________
    • Related Articles

    • iT500 - Pairing with the iT300

       iT500 : Pairing with iT300 Sensor  (1.6.2) .                   Keys / Buttons needed:  Cog/Settings    Tick/Confirm    Return/Menu  Description : Pairing establishes a communications link between your iT500 Thermostat and the iT300 Sensor. If your ...
    • iT500 - Pairing with the iT500RX Receiver

         iT500 : Pairing with iT500RX  (2.1.1) .  Keys / Buttons needed: Cog/Settings   Tick/Confirm    Return/Backup  Description : Pairing establishes a communications link between your iT500 Thermostat and the iT500RX Receiver. If your thermostat is ...
    • iT500 - Pairing with the iT500RX Receiver

       iT500 : Pairing with iT500RX  (1.6.1) .    Keys / Buttons needed: Cog/Settings   Tick/Confirm    Return/Backup  Description : Pairing establishes a communications link between your iT500 Thermostat and the iT500RX Receiver. If your thermostat is ...
    • IT500 - Receiver Lights

       iT500 : Receiver Lights  (1.3.4) . Red Light The bottom switch will show a constant red light when the iT500RX Receiver is ready to pair. Green Light When the Receiver and the Thermostat are powered and paired the bottom light will be green. Blue ...
    • IT500 - Blue Flashing Receiver Light

       iT500 : Receiver Blue Flashing Light  (7.2.2) A flashing blue light is a normal indication that the iT500 thermostat is asking / calling for heat. The boiler should be operating while this light is flashing.  For details on the meanings of the ...