iT500 - Pairing with the iT500RX Receiver

iT500 - Pairing with the iT500RX Receiver

 

 iT500 : Pairing with iT500RX  (2.1.1) . 


Keys / Buttons needed: Cog/Settings   Tick/Confirm    Return/Backup 


Description :


Pairing establishes a communications link between your iT500 Thermostat and the iT500RX Receiver. If your thermostat is failing to control your boiler or you have an orange light on the top switch of your receiver then your devices need pairing. Please follow the procedure below. 

               




Pairing Procedure :  

Please ensure the Thermostat and Receiver are more than 1 metre apart during this process.


  1. Turn the mains power to the boiler off for 5 Seconds, then turn the power back on.


  1. Insert a paperclip, pin or similar into the ‘Sync’ hole on the left underside of the receiver. Press and hold until the light on the bottom switch turns red.



  1. On the thermostat press and hold the cog key  and return key  at the same time.



  1. If the device is connected to the internet the globe and WiFi icons will be displayed.



  1. If the device is not connected to the internet just the WiFi icon is displayed



  1. Press the tick key .  A 10 minute countdown will begin. 



  1. On the Receiver the red light will now start to flash green, and then turn to a solid green light.



  1. The solid green light indicates the two devices have successfully paired.


  1. To finish pairing press the return key  until   the home screen appears.



                                               __________________________

    • Related Articles

    • iT500 - Pairing with the iT500RX Receiver

      iT500 : Pairing with iT500RX (1.6.1) . Keys / Buttons needed: Cog/Settings Tick/Confirm Return/Backup Description : Pairing establishes a communications link between your iT500 Thermostat and the iT500RX Receiver. If your thermostat is failing to ...

    • IT500 - Receiver Controls

      iT500 : Receiver Controls (1.3.3) . Description : The iT500RX receiver is the switching part of your heating system. Wired directly to your boiler, pump and control valves the receiver controls your heating and hot water systems. In the event of ...

    • IT500 - Receiver Operating Modes

       iT500 : Receiver Operating Modes (3.3.1) . Description :      The iT500RX receiver has three Operating Modes –                                                  Auto,  Manual and Off.  In the event of failure of your iT500 System, the receiver ...

    • IT500 - Receiver Lights

       iT500 : Receiver Lights  (1.3.4) . Red Light The bottom switch will show a constant red light when the iT500RX Receiver is ready to pair. Green Light When the Receiver and the Thermostat are powered and paired the bottom light will be green. Blue ...

    • IT500 - Blue Flashing Receiver Light

       iT500 : Receiver Blue Flashing Light  (7.2.2) A flashing blue light is a normal indication that the iT500 thermostat is asking / calling for heat. The boiler should be operating while this light is flashing.  For details on the meanings of the ...