KL08RF - Connect Offline to Gateway

KL08RF - Connect Offline to Gateway

KL08RF - It is possible to connect the KL08RF to a UG600 or UG800 with no internet connection.

Remove the CO10RF coordinator from the KL08RF when trying to pair to a UG600/UG800.

Plug only the power cable in the UG600/UG800 and let it stay on solid Red.

Power up the KL08RF and let the wiring centre to start up for 10-15 sec.

On the KL08RF now press the Reset button once and the Network Status light will flash.

Now Press and hold the button on the UG for 5 seconds: UG600 light will flash red, UG800 Zigbee light will go Orange.

When KL08RF Network Status light goes solid Red the KL08RF is connected to the UG600/UG800

See KL08RF Quick guides Installation section: content


    • Related Articles

    • KL08RF - Manual and Spec Sheet

                           The KL08RF has 8 control zones, each with connections for up to 3 heating zones (actuators). The pump logic and boilers logic, a connection for Dew point sensor and the C/O input for automatic switching from heating to cooling ...

    • KL08RF + SQ610RF + CO10RF First time setup

      Connect KL08RF + SQ610RF + CO10RF – First time setup Step 1: Turn on the devices 1.1. Plug in the CO10RF coordinator. 1.2. Power up the KL08RF via mains. 1.3. Make sure SQ610RF is charged and is ON - hold Tick to turn on. Step 2: Check Lights 2.1. On ...

    • KL08RF - Wiring Diagram

      KL08RF : Wiring Diagram (1.1.1) . __________________________