RT310 Series Thermostat Videos

RT310 Series Thermostat Videos

Pairing.
​
​Follow this procedure if you have a red flashing light on your Receiver.​​


Receiver Controls ( Auto/Manual Mode, LED's Explained)


Common Issues and Frequently Asked Questions

General Use : Turning your Heating On


Blank Screen - No Display (after changing the batteries).


Unable to change Temperature and 5'C on the screen.

 


Procedures and Configuration Settings.

Frost Setpoint.


Temperature Offset



Temperature Display Increments




                                                    ____________________________

    • Related Articles

    • RT310 Series Manuals

    • RT310RF & RT310TX - Thermostat Setup - Dip Switches

      RT310RF : Thermostat Setup – Dip Switch Settings (1.4.1) . Thermostat Dip Switches : On the back of the thermostat there are two small dip switches. CPH Setting or The Maximum ‘Cycles Per Hour’. This is the number of times per hour that your boiler ...

    • RT310RF - Installer Mode

      RT310RF : Installer Mode (1.4.2) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter Description Default Value ...

    • RT310RF - Low Battery Warning

       RT310RF : Low Battery Warning  (4.2.1) .                                                                                                                Key                                                    Function                                   ...

    • Issue 64545. Boiler isn’t working even though there is a flame symbol on thermostat

      Thermostat and receiver may have lost pairing. Pair as per quick guide. Boiler is still not working? Check; *Receiver has power? (observe power LED). *Receiver is in ON and AUTO mode position? Place in these positions. *Receiver ON LED has activated? ...