RT310RF - Adjusting Setpoint Temperature

RT310RF - Adjusting Setpoint Temperature

 RT310RFAdjusting the Setpoint Temperature  (3.2.1) .

                        

                                    Buttons Used and  


Description :


By changing the Setpoint temperature, you are permanently altering your temperature. You can change the set point temperature very easily while you are reviewing the set point temperature. 



Procedure :




  1. Press the or  arrow keys repeatedly to change the temperature setting.

(Actual Room Temperature)



  1. The set point temperature will flash to indicate that it can be changed: the temperature will be changed in  0.5°C   steps per key press.

(Setpoint Temperature)



  1. The Thermostat will return to Normal mode if no keys are pressed for more than 2 seconds. 

Your selected temperature has now been set and is a permanent override until a new Setpoint Temperature is selected.

(2 Seconds Timeout)



  1. After a couple of seconds your thermostat will return to Normal Mode with the current room temperature displayed on the screen

In this example the thermostat is now calling for heat to reach the new setpoint temperature.



  1. Setpoint temperature cannot be changed if Frost Protection mode is enabled and there is a frost symbol on the display.


Exit Frost Protection Mode by pressing the Frost Button and then restart this procedure.


                                              ________________________


    • Related Articles

    • RT310RF - Reviewing the Setpoint Temperature

       RT310RF : Reviewing Setpoint Temperature  (3.1.1) . Reviewing The Setpoint Temperature :                                                                                                    Buttons Used and   Description :                         To ...
    • RT310RF - Temperature Display Increments

      RT310RF : Installer Mode – Temperature Display Increments (4.8.1) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function ...
    • RT310RF - Frost Setpoint

      RT310RF : Installer Mode – Frost Setpoint (4.4.2) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter ...
    • RT310RF - Temperature Offset

      RT310RF : Installer Mode – Temperature Offset (4.3.1) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter ...
    • RT310RF - Unable to change Temperature and 5'C on the screen - Frost Protection

      ​  RT310RF : 5’C on screen and unable to change temperature  (6.2.3) .                                                          Buttons Used   Description : If your display is showing 5’C (or a figure between 5’C and 17’C) and you are unable to ...