RT310RF - Frost Setpoint

RT310RF - Frost Setpoint



 RT310RFInstaller Mode – Frost Setpoint (4.4.2) .


Description :      Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below.



Setting No.

Function

Parameter

Description

Default Value

d01

Temperature Display Increments

0.1°C or 0.5°C

Select the temperature display increments.

0.5°C

d02

Temperature Offset

+/-3.0°C

Calibrate your thermostat temperature.

0.0°C

d03

Frost Setpoint

5.0°C to  17.0°C

Set the Frost Point Temperature.

5.0°C


Procedure :



  1. Press and hold the and  and keys all together to enter Installer Mode and the installation settings.




  1. The first setting is Temperature Display Resolution selection – ‘d01’ which will be displayed on the screen. Press the  to enter the setting.




  1. The current setting will be displayed flashing on the screen. Use the and arrow keys to change the selection.





  1. To continue to the second setting press the button and ‘d02’ will be displayed on the screen. To enter the setting press the  button again, alternatively wait for ten seconds and the thermostat will return to its Normal Mode and display the current temperature.




  1. The current setting will be displayed flashing on the screen. Use theand arrow keys to change the selection.




  1. To continue to the third setting press the  button and ‘d03’ will be displayed on the screen. To enter the setting press the button again, alternatively wait for ten seconds and the thermostat will return to its Normal Mode and display the current temperature.




  1. The current setting will be displayed flashing on the screen. Use the and arrow keys to change the selection.




  1. Press the  button or simply wait for ten seconds to exit the Installer Mode and return to the normal temperature screen.




  

                                                      ______________________


    • Related Articles

    • RT310RF - Installer Mode

       RT310RF : Installer Mode  (1.4.2) . Description :      Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter Description Default ...
    • RT310RF - Frost Protection

       RT310RF : Frost Protection  (4.4.1) .                                                          Buttons Used   Description : Frost Protection Mode ensures that the temperature of your home does not fall below a certain point to prevent your pipes ...
    • RT310RF - Adjusting Setpoint Temperature

       RT310RF : Adjusting the Setpoint Temperature  (3.2.1) .                                                              Buttons Used and   Description : By changing the Setpoint temperature, you are permanently altering your temperature. You can change ...
    • RT310RF - Reviewing the Setpoint Temperature

       RT310RF : Reviewing Setpoint Temperature  (3.1.1) . Reviewing The Setpoint Temperature :                                                                                                    Buttons Used and   Description :                         To ...
    • RT310RF - Unable to change Temperature and 5'C on the screen - Frost Protection

      ​  RT310RF : 5’C on screen and unable to change temperature  (6.2.3) .                                                          Buttons Used   Description : If your display is showing 5’C (or a figure between 5’C and 17’C) and you are unable to ...