RT310RF : How it Operates  (1.2.1) .

The RT310RF room thermostat simply switches the heating system on and off as necessary by transmitting a signal via RF to the Receiver which in turn is connected to your system boiler. It works by sensing the air temperature, switching on the heating when the air temperature falls below the thermostat setting, and switching it off once this set temperature has been reached. 

Turning a room thermostat to a higher setting will not make the room heat up any faster. How quickly the room heats up depends on the design of the heating system, for example, the size of boiler and radiators. Neither does the setting affect how quickly the room cools down. Turning a room thermostat to a lower setting will result in the room being controlled at a lower temperature and saves energy. The heating system will not work if a time switch or programmer has switched it off. 

The way to set and use your room thermostat is to find the lowest temperature setting that you are comfortable with, and then leave it alone to do its job. The best way to do this is to set the room thermostat to a lower temperature – say 18⁰C – and then turn it up by one degree each day until you are comfortable with the temperature. You will not have to adjust the thermostat further. Any adjustment above this setting will waste energy and cost you more money. 

If your heating system is a boiler with radiators, there will usually be only one room thermostat to control the whole house. You can however have different temperatures in individual rooms by installing thermostatic radiator valves (TRVs) on individual radiators. If you do not have TRVs, you should choose a temperature that is reasonable for the whole house. If you do have TRVs, you can choose a slightly higher setting to make sure that even the coldest room is comfortable, then prevent any overheating in other rooms by adjusting the TRVs. 

Room thermostats need a free flow of air to sense the temperature, so they must not be covered by curtains or blocked by furniture. Do not install them near electric fires, televisions, wall or table lamps, do not place them above a radiator and where possible do not install them on an ‘outside’ room wall or on a wall that receives direct sunlight from a window opposite. Any of these may prevent the thermostat from working properly.