RT310RF - Operating Keys & Buttons

RT310RF - Operating Keys & Buttons

 RT310RF : Operating Keys and Buttons  (1.6.1) .


Description :


There are few user controls for the RT310RF, making this thermostat very easy to operate. These controls are shown below, along with a description of each of their functions. The temperature displayed on the LCD is the current room temperature.




Key

                                                   Function                                                                                      



   Turns on the LCD Backlight.


 


   Turn On / Off the Frost Mode.




   The Increase Button.


 


   The Decrease Button.


 

  

  


   The RF Test and Pairing Button. Press once for RF Test Mode. 

   Press and hold for 3 Seconds to Enter / Exit Pairing Mode





   Press all three buttons for 3 Seconds to enter Installer Mode.




                                                            __________________________

    • Related Articles

    • RT310RF - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...

    • RT310RF & RT310TX - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...

    • RT310RF & RT310TX - Thermostat Setup - Dip Switches

      RT310RF : Thermostat Setup – Dip Switch Settings (1.4.1) . Thermostat Dip Switches : On the back of the thermostat there are two small dip switches. CPH Setting or The Maximum ‘Cycles Per Hour’. This is the number of times per hour that your boiler ...

    • RT310RF - Installer Mode

      RT310RF : Installer Mode (1.4.2) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter Description Default Value ...

    • RT310RF - Low Battery Warning

       RT310RF : Low Battery Warning  (4.2.1) .                                                                                                                Key                                                    Function                                   ...