RT310RF - Receiver Controls

RT310RF - Receiver Controls



 RT310RF : Receiver Controls  (1.3.3) .


Description :


The RXRT510 receiver is the switching part of your heating system. Wired directly to your boiler, pump and control valves the receiver controls your heating.



                


Red LED

ON

OFF


The receiver is on and successfully paired.



 When in Manual Mode, ON will turn the Boiler On. 



When in Manual Mode,   Off will turn the Boiler Off.


Green LED

Auto

Manual


The Thermostat is calling for Heat and the Boiler has been switched On.



The system receiver output will switch On and Off in relation to the command from the Thermostat.



The system receiver output is controlled by use of the On / Off slide switch..



                                                                           ___________________________

    • Related Articles

    • RT310RF - Pairing with the RXRT510 Receiver

      ​  RT310RF : Pairing with the RXRT510 Receiver  (2.1.1) . ​ Description : Pairing establishes a communications link between your Thermostat and the Receiver. If your thermostat is failing to control your boiler then your devices probably need ...

    • RT310RF & RT310TX - Pairing with the RXRT510 Receiver

      ​  RT310RF : Pairing with the RXRT510 Receiver  (1.5.1) . Description : Pairing establishes a communications link between your Thermostat and the Receiver. If your thermostat is failing to control your boiler then your devices probably need ...

    • RT310RF - Red Flashing Light on the Receiver

       RT310RF : Red Flashing Light on the Receiver - Pairing (6.2.2) . Description : A red flashing light on your Receiver means that the communications link between your Thermostat and Receiver has been lost and your devices need ...

    • RT310RF & RT310TX - Thermostat Setup - Dip Switches

      RT310RF : Thermostat Setup – Dip Switch Settings (1.4.1) . Thermostat Dip Switches : On the back of the thermostat there are two small dip switches. CPH Setting or The Maximum ‘Cycles Per Hour’. This is the number of times per hour that your boiler ...

    • RT310RF - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...