RT310RF - Sleep Mode

RT310RF - Sleep Mode



 RT310RF : Sleep Mode  (4.5.1) .

                                                          

                                              Buttons Used  and    



Description :


Sleep Mode allows your Thermostat to be put into a state where all of its functions are paused / switched off to save battery power. Whilst in Sleep Mode, the thermostats LCD Display will be blank and ALL output from the Control Unit is immediately turned off.

                                                                   


To Activate : 



Simply press and hold the two arrow keys  and   .

                                          


To De-Activate :

To wake up the RT310RF and cancel Sleep Mode, press any key.



                                                       ___________________________

    • Related Articles

    • RT310RF - Installer Mode

      RT310RF : Installer Mode (1.4.2) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter Description Default Value ...

    • RT310 Series Manuals

    • RT310RF - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...

    • RT310RF & RT310TX - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...

    • RT310RF - Temperature Offset

      RT310RF : Installer Mode – Temperature Offset (4.3.1) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter ...