RT310RF - Temp Out Of Range Hi & Lo

RT310RF - Temp Out Of Range Hi & Lo

 RT310RFTemperatures Outside Operating Range  (4.7.1) .


                        


 

Description :


Temperatures below 10 °C are displayed without the leading ‘0’. Temperatures exceeding the measurable range will be indicated by ‘HI’ for temperatures above the upper limit, and ‘LO’ for temperatures below the lower limit, as shown in the images above.


The operating range of the RT310RF Thermostat is from 5.0°C for the lower limit to a maximum of 35.0°C for the upper limit.




                                                          _________________________________

    • Related Articles

    • RT310RF - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...
    • RT310RF & RT310TX - Testing the RF Transmissions

      RT310RF : Testing the RF Transmissions  (1.5.2) . Description :                        It is important to site both the receiver and thermostat in locations where the RF (Radio Frequency) signal cannot be interrupted. The receiving range between the ...
    • RT310RF - Adjusting Setpoint Temperature

      RT310RF : Adjusting the Setpoint Temperature (3.2.1) . Buttons Used and Description : By changing the Setpoint temperature, you are permanently altering your temperature. You can change the set point temperature very easily while you are reviewing ...
    • RT310RF - Reviewing the Setpoint Temperature

       RT310RF : Reviewing Setpoint Temperature  (3.1.1) . Reviewing The Setpoint Temperature :                                                                                                    Buttons Used and   Description :                         To ...
    • RT310RF - Temperature Offset

      RT310RF : Installer Mode – Temperature Offset (4.3.1) . Description : Installer Mode takes you into the device installation settings which on the RT310 Series allows you to change the settings in the table below. Setting No. Function Parameter ...