Description :      Installer Mode takes you into the device installation settings which on the RT510 Series allows you to change the settings in the table below.

Setting No.

Function

Parameter

Description

Default Value

d01

Temperature Display Increments

0.1°C or 0.5°C

Select the temperature display increments.

0.5°C

d02

Temperature Offset

+/-3.0°C

Calibrate your thermostat temperature.

0.0°C

d03

Frost Setpoint

5.0°C to  17.0°C

Set the Frost Setpoint Temperature.

5.0°C

d04

Programmer Selection

5/2 days or Individual (7D)

Select which Programming Mode Option is used.

5/2d

1.  Slide down the front cover to reveal the   and  buttons.
   

1. Press and hold the and  and  buttons all together to enter Installer Mode and the installation settings.
   

2. The first setting is Temperature Display Increments  – ‘d01’ will be displayed on the screen. 
   

Press the  button until the setting parameter ‘D04’ is displayed on the screen. 

3. This is the setting parameter for Programming Mode Selection.
   

To enter the setting press the  button.

4. The current setting will now be displayed flashing on the screen. Use the Up and Down arrow keys to choose between 52d  ( 5 / 2 - Weekdays and Weekend setting) or 7d ( Individual Days). 
   

      Please see ‘Programming Schedules Explained’               article.

5. You can now press the  button repeatedly until the display shows the current room temperature, or alternatively,  simply wait for ten seconds without pressing any buttons.  
   

6. The thermostat will return to its Normal Mode and display the current time and temperature.