Description :  If you want to use your thermostat Manually to select your desired room or setpoint temperature,  rather than running to set programme schedules you need to select Manual Mode.

Procedure :  To use the thermostat in Manual Mode please follow this procedure.

    

1. Press the hand button once, this is located on the left-hand side of the thermostat under the +HR button. 

This will put the thermostat into Manual mode and prevent any Program Schedules from running.

2. A Hand Symbol will be displayed on the screen to show you are in Manual Mode.

3. Use your Up and Down Arrow buttons to select your desired or ‘setpoint’ temperature.

4. To turn your heating on, you will need to raise the set point temperature above the current room temperature. 

In this example the setpoint has been set to 24’C as the room temperature is currently showing as 23’C.

5. A flame symbol will be displayed showing the thermostat is now calling for heat and your boiler will run until the room reaches the new set point.

6. The desired setpoint temperature will now be maintained and the boiler will only run when the room temperature drops below your selected temperature to bring it back up to the setpoint.

7. If you want to reduce your setpoint temperature, use the Down Arrow button to change the setpoint to below your current room temperature. 

The flame symbol will disappear to show the thermostat is no longer calling for heat, and your boiler will stop.

8. To exit Manual Mode and return to your program schedules, simply press the hand button. The hand symbol will be removed from the screen, and you should now see a programme number in the bottom left-hand corner.  This is the current programme.