Question: How do I get the RX30RF into pairing mode, to be able find it with the app and Salus gateway?
Answer: Power on the RX30RF, after a few seconds both LEDs should flash red rapidly.
Short press the pair button, less than a second, with a paperclip or similar tool.
The LED flash rate will slow down to show its ready to pair.
Question: How do I connect my RX30RF to a network?
Answer: The RX30RF will only connect to the SALUS Universal Gateway and our app.
When the gateway is set up, put the RX30RF into pairing mode with a short press of the pair button. Both red LEDs should have a slower flash rate.
Search for the device in the app to add it to your gateway.
Question: How do I set the RX30RF DIP switches for OpenTherm on my boiler? Which switches should be on and which off?
Answer: Make sure the DIP switch positions are set for Heating Only, with all switches in the up position. If they are set to any other mode, the receiver won't work with OpenTherm.
If you do make changes to the DIP switches for OpenTherm control, you must factory reset the receiver for the new switch positions to take effect.
Make sure the compatible boiler is connected to the OpenTherm terminals A and B on the receiver.
RX30RF system type selection – DIP switches 1-4 for Heating Only.
OpenTherm boiler control wiring – receiver terminals A and B to the boiler's OpenTherm terminals.