SPE600 - FAQs

SPE600 - FAQs

Question: The plug doesn't turn on when I try to press the side button of the SPE600?
Answer: Remove the SPE600 from the mains for a minute, then plug it back in. Wait 30 seconds then re-test the switch. If it still won't work, factory reset the smart plug and then re-add it to the app and test again.

    • Related Articles

    • T30NC230 - FAQs

      Question: The T30NC230 is not working. Answer: Troubleshooting the T30N230 should only be done by a competent person / installer. If the actuator is not opening, carry out electrical checks using a multimeter. Please note that the T30NC230 is a slow ...

    • TS600 - FAQs

      Question: How do I update firmware on the TS600? Answer: The universal gateway manages Firmware updates automatically and only applies them when needed. Question: How do I reset and re-pair TS600 with Salus Gateway? Answer: IF the device has ...

    • RX10RF - FAQs

      Question: What thermostats are compatible with RX10RF? Answer: The RX10RF is a receiver from the smart home range meaning it is not a simple thermostat to receiver unit. The RX10RF works only in a coordinator like CO10RF (offline) or a gateway ...

    • SR600 - FAQs

      Question: Can SR600 be used outside? Answer: SR600 relays are not suitable for environments where extreme moisture or humidity can occur. The device has an IP rating of IP30 Question: The app doesn't turn my hot water on in line with the schedule, ...

    • VS20WRF - FAQs

      Question: Whenever we try to decrease the temperature on the VS20WRF thermostat, it goes back up? Answer: A digital thermostat from Salus Controls will show the current room temperature. When you make an adjustment and turn it up or down, the display ...