Question: Can SR600 be used outside?
Answer: SR600 relays are not suitable for environments where extreme moisture or humidity can occur. The device has an IP rating of IP30
Question: The app doesn't turn my hot water on in line with the schedule, and when I override it on it clicks off?
Answer: An SR600 used for hot water control should not also be linked to a thermostat. If it is, the thermostat's demand will override the relay's scheduling. For hot water relay control it is usual to just run a schedule on the SR600 smart relay from the app, or control it with One Touch Rules.
Question: How do I mount the Salus SR868 relay?
Answer: The relay can be mounted inside a wall box Ø 60mm - we recommend using deep wall boxes. Alternatively, you can mount it on a DIN rail using the DRC-1 mount: DRC-1 Mechanical DIN Rail Mounting Accessory.
Related Articles
T30NC230 - FAQs
Question: The T30NC230 is not working. Answer: Troubleshooting the T30N230 should only be done by a competent person / installer. If the actuator is not opening, carry out electrical checks using a multimeter. Please note that the T30NC230 is a slow ...
TS600 - FAQs
Question: How do I update firmware on the TS600? Answer: The universal gateway manages Firmware updates automatically and only applies them when needed. Question: How do I reset and re-pair TS600 with Salus Gateway? Answer: IF the device has ...
RX10RF - FAQs
Question: What thermostats are compatible with RX10RF? Answer: The RX10RF is a receiver from the smart home range meaning it is not a simple thermostat to receiver unit. The RX10RF works only in a coordinator like CO10RF (offline) or a gateway ...
VS20WRF - FAQs
Question: Whenever we try to decrease the temperature on the VS20WRF thermostat, it goes back up? Answer: A digital thermostat from Salus Controls will show the current room temperature. When you make an adjustment and turn it up or down, the display ...
SPE600 - FAQs
Question: The plug doesn't turn on when I try to press the side button of the SPE600? Answer: Remove the SPE600 from the mains for a minute, then plug it back in. Wait 30 seconds then re-test the switch. If it still won't work, factory reset the ...