Question: The
T30NC230 is not working.
Answer: Troubleshooting
the T30N230 should only be done by a competent person / installer. If the actuator is not opening, carry out
electrical checks using a multimeter.
Please note that the T30NC230 is a slow opening / closing valve,
requiring several minutes to open or close.
Removal from the manifold may be required to test but again, should only
be carried out by a competent person or installer.
Question: I need an adapter for my T30NC230, so that I
can connect it to my UFH manifold.
Answer: The
T30NC230 has a 30mm thread. Salus
Controls do not make any adapters, however, so you will have to contact your
manifold adapter for advice. The data
sheet for the T30NC230 may be found here;