TS600 - FAQs

TS600 - FAQs

Question: How do I update firmware on the TS600?
Answer: The universal gateway manages Firmware updates automatically and only applies them when needed.


Question: How do I reset and re-pair TS600 with Salus Gateway?
Answer: IF the device has previously been paired then perform a factory reset
To perform a reset, press and hold the touch button for  10 seconds. 
The LED will turn red for 5 seconds. TS600 will leave any network and reset. 
Once completed, the TS600 will re-enter pairing mode.


Question: Can I sue my TS6t00 thermostat with Salus Sense?
Answer: Salus sense will only work with Quantum thermostats as well as the VS10, VS20 and Elypso models


    • Related Articles

    • T30NC230 - FAQs

      Question: The T30NC230 is not working. Answer: Troubleshooting the T30N230 should only be done by a competent person / installer. If the actuator is not opening, carry out electrical checks using a multimeter. Please note that the T30NC230 is a slow ...

    • RX10RF - FAQs

      Question: What thermostats are compatible with RX10RF? Answer: The RX10RF is a receiver from the smart home range meaning it is not a simple thermostat to receiver unit. The RX10RF works only in a coordinator like CO10RF (offline) or a gateway ...

    • SR600 - FAQs

      Question: Can SR600 be used outside? Answer: SR600 relays are not suitable for environments where extreme moisture or humidity can occur. The device has an IP rating of IP30 Question: The app doesn't turn my hot water on in line with the schedule, ...

    • VS20WRF - FAQs

      Question: Whenever we try to decrease the temperature on the VS20WRF thermostat, it goes back up? Answer: A digital thermostat from Salus Controls will show the current room temperature. When you make an adjustment and turn it up or down, the display ...

    • SPE600 - FAQs

      Question: The plug doesn't turn on when I try to press the side button of the SPE600? Answer: Remove the SPE600 from the mains for a minute, then plug it back in. Wait 30 seconds then re-test the switch. If it still won't work, factory reset the ...